Safety First, At Last!


The first knockings of my wheel-guard for the lathe - the frame for the top of it shown on top of the aluminium sheet that will form the body of the guard, the length of 10mm Ali angle ready to be cut for the frame. The lug on the top frame will be located by the hex-bolt that normally secures the cast iron guard that shields the bull and back-gears - the rest of it will be supported from the motor bearers or the bench itself, depending how this particular improvisation goes! Keep you posted... 

Comments

  1. Did you don the loin-cloth and use yer feet Kel?:):)

    ReplyDelete
  2. Not for a while, now: I find getting up a bit of a struggle, these days...;0)

    ReplyDelete

Post a Comment

Popular posts from this blog

Of Feedback & Wobbles

A Time of Connection

Sister Ray